联系我们收藏本站在线留言网站地图欢迎进入唐山天物彩板集团有限公司官网!

彩板厂家_彩涂板价格_彩涂卷厂家_彩涂板价格_天物集团

天物彩板-始于2004 专注功能性高端彩板生产销售
服务热线: 400-060-9166
服务热线: 13931586578
彩板厂家

彩涂板屋面是一种新型面板

返回列表 来源: 发布日期: 2020.08.31

彩涂板屋面是一种新型面板

天物彩板专注彩板行业16年——河北沧州彩涂板屋面安装生产请拨打网站上方电话详细咨询


彩涂板屋面是一种新型的面板,被认为是现代建筑最理想的材料,使用寿命长。彩涂板屋面作为底板安装时有许多注意事项,应由专业施工师傅安装。铝镁锰屋面板由铝镁锰板制成。即使长期使用,这种材料也不会腐蚀。一般情况下,可使用40年,避免影响未来使用效果。具体安装注意事项如下:
安装前应将彩涂板顶板上的污染物清理干净,以防面板腐蚀。另外,安装时应注意面板的平整度,不得有弯曲变形。彩涂板屋面相互重叠有一个波峰,因此得到了许多用户的认可。整个铝镁锰屋面板系统采用机械锁紧方式,可避免漏水的发生,排水系统良好。特别是在暴雨天气,能及时放水,避免水挤压产生的巨大压力,防止工程变形。这样会更坚固,不会有泄漏。锚固可靠,安装平整,板间无缝隙。
彩涂板顶、地板安装应顺直,由高到低。采用成熟的防雷系统设计。屋面板可作为避雷器使用,无需设置避雷带。也可与避雷带或避雷针配合使用,形成安全的多重防雷系统;安装方式由中到边,搭接方式由低到高。地板安装的起跑线安装完毕后,选用自攻螺钉将两端卡住,然后安装第二块板。如需安装第二块彩涂板,应在屋面做标记,并检查其偏差是否符合设计要求。如达不到要求,应调整后再完全拧紧。安装后注意检查是否有遗漏。如果紧固不够,会有渗漏,必须注意

Color coated sheet roof is a new type of panel, which is considered to be the most ideal material for modern buildings, and has a long service life. There are many points for attention when installing color coated sheet roof as bottom plate, which should be installed by professional construction master. Aluminum magnesium manganese roof panel is made of aluminum magnesium manganese plate. Even if it is used for a long time, this type of material will not corrode. Under general conditions, it can be used for 40 years to avoid affecting the future use effect. The specific installation precautions are as follows:

Before installation, it is necessary to clean the pollutants on the roof of the color coated plate to avoid the corrosion of the panel. In addition, the flatness of the panel should be paid attention to during the installation, and there should be no bending deformation. The color coated sheet roof overlaps a wave crest with each other, so it has been recognized by many users. The whole system of aluminum magnesium manganese roof panel adopts the mechanized locking mode, which can avoid the occurrence of water leakage and has a good drainage system. Especially in the heavy rain weather, the water can be discharged in time, which can avoid the huge pressure caused by water extrusion and prevent the deformation of the project. This will be more solid, there will be no leakage. It is better to anchor reliably, keep the installation flat, and there should be no gap between the plates.
The installation of color coated board roof and floor shall be smooth, from high to low. The mature lightning protection system design shall be adopted. The roof panel can be used as the lightning arrester without the need for lightning protection belt. It can also be used together with the avoidance belt or lightning rod to form a safe multiple lightning protection system; the installation mode from the middle to the edge, and the lap joint mode from the low to the high. After the installation of the starting line of the floor installation, select the self tapping screw to imprison both ends, and then install the second plate. If the second color coated plate needs to be installed, the roof shall be marked, and the deviation of the plate shall be checked to meet the design requirements. If it cannot meet the requirements, it shall be adjusted and then fully tightened. After installation, pay attention to check whether there is any omission. If the fastening is not enough, there will be leakage, which must be paid attention to.

咨询热线

400-060-9166