多个彩涂镀锌板怎么进行搭接

天物彩板专注彩板行业16年——更多安徽彩涂镀锌板安装厂家_彩钢板安装加工方式请拨打网站上方电话咨询

使用彩涂镀锌板它的连接成了一个问题。你知道如何搭接多色镀锌板吗？如果圈速不好，就会出现问题。
搭接的基本方法有绑扎搭接、焊接、机械连接等，彩涂镀锌板一般用铆钉或螺栓固定。对于彩涂板的侧面和端部搭接，安装彩涂板是一个重要的环节，搭接效果影响到后续的安装。今天，我就来和大家分享一下如何将几块彩涂镀锌板重叠
首先用夹钳夹住重叠的钢板。钢板沿纵向就位时，端部特别是上端要用钳子夹住，以保证钢板一端就位，另一端的搭接也在正确位置，以固定钢板。在固定过程中，夹钳应始终沿纵向夹住钢板。
注意每块钢板的安装，其边缘搭接应准确地放在上一块钢板上，并与上一块钢板夹紧，直至钢板两端固定。在安装下一个板之前，每个板必须完全固定。固定必须从钢板的中心开始，然后延伸到两侧，最后固定钢板的搭接边缘。

The use of color coated galvanized sheet can not be one, so its connection has become a problem. Do you know how to lap multiple color coated galvanized sheet? If the lap is not good, there will be problems.

The basic methods of lap joint are binding lap, welding, mechanical connection, etc. The color coated galvanized sheet is usually fixed with rivets or bolts. For the side and end lap of color coated galvanized sheet, it is an important step to install color coated galvanized sheet, and the lap effect affects the later installation. Today, I'd like to share with you how to overlap several color coated galvanized sheets
First, clamp the overlapped steel plate with a pair of clamp pliers. When the steel plate is in place along the longitudinal direction, the end, especially the upper end, needs to be clamped with pliers to ensure that one end of the steel plate is in place, and the overlap of one end is also in the correct position, so as to fix the steel plate. In the process of fixation, the clamp should always clamp the steel plate in the longitudinal direction.
Pay attention to the installation of each steel plate, its edge lap should be accurately placed on the previous steel plate, and clamped with the previous steel plate until both ends of the steel plate are fixed. Each plate must be fully secured before the next plate is installed. The fixation must start at the center of the plate, then extend to both sides, and finally fix the lap edge of the plate.