联系我们收藏本站在线留言网站地图欢迎进入唐山天物彩板有限公司官网!

彩板厂家_彩涂板价格_彩涂卷厂家_彩涂板价格_唐山彩涂板厂家

天物彩板-始于2004 专注功能性高端彩板生产销售
服务热线: 400-060-9166
服务热线: 13931586578
彩板厂家

彩钢板如何上墙

返回列表 来源: 发布日期: 2020.05.22

彩钢板如何上墙

天物彩板专注彩板行业16年——立面彩钢板报价_5公分彩钢板价格表请拨打网站上方电话咨询

立面彩钢板报价_5公分彩钢板价格表_天物彩板

彩钢板对每个人来说都不是新鲜事物,那么彩钢板是如何贴到墙上的呢?今天,吉林彩钢板为大家详细介绍:
首先,安装前要在上表面上标示彩色钢板的安装位置,基础(楼板梁)的顶面应填满1:3水泥砂浆或细石混凝土。第一块彩钢板安装时,20 mm后用1:3水泥砂浆垫层,用木楔控制水平,接缝处用1:3水泥砂浆嵌缝。
另外,彩钢板调平调直后,顶面两端用不锈钢接头或厚度不小于4mm的钢板固定,并做防锈处理。连接件的另一端应与混凝土埋件连接或钩在钢柱边缘。
其次,在板缝两端的接缝处涂胶。每5块横向板设10 mm厚角钢支撑。角钢的一条腿与混凝土埋件或钢筒表面焊接,另一条腿用空心钉固定在横向板内。每块墙板或整栋房屋外墙板的上层应采用均质砂和混凝土。使用彩钢板时,应采用螺栓和结构固定。
此外,彩钢板与基础之间的连接以及彩钢板之间的连接应用密封胶密封。端缝宽度为10-15mm,缝内填充玻璃棉或岩棉,嵌入聚乙烯棒后用密封胶密封。

Color steel late is not new to everyone, so how does color steel plate get on the wall? Today, Jilin color steel plate gives you a detailed introduction:

Firstly, the installation position of the color steel plate shall be indicated on the upper surface before installation, and the top surface of the foundation (floor beam) shall be filled with 1:3 cement mortar or fine stone concrete. When the first color steel plate is installed, it shall be bedded with 1:3 cement mortar after 20mm, and the level shall be controlled by wooden wedge, and the joint shall be inlaid with 1:3 cement mortar.
In addition, after the color steel plate is leveled and straightened, both ends of the top surface shall be fixed with stainless steel connectors or steel plates with thickness of no less than 4mm and rust proof treatment. The other end of the connector shall be connected with the concrete embedded part or hooked on the edge of the steel column.
Secondly, adhesive shall be applied to the joints at both ends of the slab joint. 10 mm thick angle steel support shall be set for every 5 transverse plates. One leg of the angle steel shall be welded with the concrete embedded parts or steel cylinder surface, and the other leg shall be fixed with hollow nails into the transverse plate. Homogeneous sand and concrete should be used for the upper layer of each wall panel or the whole exterior wall panel of the house. When color steel plate is used, it should be fixed with bolts and structure.
In addition, the joint between the color steel plate and the foundation and the joint between the color steel plate shall be sealed with sealant. The width of the end joint shall be 10-15mm, and the joint shall be filled with glass wool or rock wool, which shall be sealed with sealant after embedded into PE rod.

咨询热线

400-060-9166