防锈合金铝板的使用方法

天物彩板专注彩涂卷行业17年——防锈合金铝板的使用方法_合金彩涂铝卷加工压型请拨打网站上方电话咨询

1.开槽：用开槽机或锣机开槽时，应使用大于90°的半圆头铣刀。切割既不会太深而伤害铝，也不会太浅而无法折叠。留一个0.2-0.3mm厚的塑料芯用铝压接，以增加强度和韧性，否则压接时铝板可能开裂或油漆可能爆裂。

2.电弧加工：采用专用的弯曲工艺设备加工电弧，缓慢施力，使板材逐渐发展到企业所需的曲面。不要一次弯曲成型。
3.安装方向：安装在同一平面上的同色铝板应沿流向一致，否则可能造成视觉色彩。
4.使用环境条件：内墙板应在室内设计使用，不得安装在室外，以保证企业的教学效果和使用寿命。
5.撕膜：保护膜应在铝板安装后45天内去除，否则可能难以撕膜或去除胶水。
6.批次：同一型号不同批次的板材可以有颜色，不同批次的金属板材可以销售和使用。在色彩比例方案中，我公司主要从事铝合金板材、图案板材等，并在同一平面上使用前具有色觉。
7.搬运：搬运板材的企业应同时提升板材的四边。严禁推、拉、拔，以免划伤板面。
8.储存：合金板应存放在干燥、通风、平整的地方，不得有踩踏和撞击。

1. Slotting: when slotting with slotting machine or gong machine, semi-circular head milling cutter greater than 90 ° shall be used. The cutting is neither too deep to hurt the aluminum, nor too shallow to make the folding. A 0.2-0.3mm thick plastic core shall be left to be crimped with the aluminum to increase the strength and toughness, or the aluminum plate may crack or the paint may burst during crimping.

2. Arc processing: some special bending technology equipment shall be used to process the arc, and the force shall be applied slowly, so that the plate can gradually develop to the curved surface required by the enterprise. Do not bend and form at one time.
3. Installation direction: aluminum plates of the same color installed on the same plane should be consistent along the flow direction, otherwise it may cause visual color.
4. Service environment conditions: the inner wall panel shall be designed and used indoors and shall not be installed outdoors, so as to ensure the teaching effect and service life of the enterprise.
5. Film tearing: the protective film shall be removed within 45 days after the installation of aluminum plate, otherwise it may be difficult to tear the film or remove the glue.
6. Batch: different batches of the same model plate can be color, and different batches of metal plates sold and used. When the color proportion of the program, our company is mainly engaged in aluminum alloy plate, pattern plate, etc., and has color perception before use on the same plane.
7. Handling: the enterprise handling the plate shall lift the four sides of the plate at the same time. Pushing, pulling and extraction are strictly prohibited to avoid scratching the plate surface.
8. Storage: alloy plates should be stored in a dry and ventilated place on a flat surface, and one without stepping and impact.