As a curtain wall material, aluminum veneer is very dangerous to users if it has no matching quality, and the safety and quality of construction engineering cannot be guaranteed. It is very unfavorable for the whole aluminum veneer industry. Low quality
aluminum veneer sold at low price will make users lose confidence in aluminum veneer products. Therefore, we must resolutely resist low-quality aluminum veneer products.
In the aluminum veneer industry, the quality not only affects the decoration effect, but also affects its practicability. So, what are the factors affecting the quality of aluminum veneer? The following is a brief introduction.
1. Cutting corners
With the continuous improvement of the national quality control system, the phenomenon of cutting corners has not been as rampant as before. However, some enterprises still take the risk to reduce the production cost. In the process of producing aluminum
veneer products, they cut corners and use molds with substandard quality, which leads to unqualified wall thickness of aluminum plate stressed bar.
2. Mixed raw materials
As the aluminum veneer industry has not yet established a relatively
perfect and mature industry standard, the quality of raw materials is uneven. Some enterprises want to win in the fierce market competition with low price, so they use the mixed aluminum with different components or mix the recycled aluminum raw materials
into the production raw materials, so as to reduce the production cost.
3. Lax supervision
Some enterprises have not established a sound supervision system, and there are loopholes in the supervision of raw materials, which makes some raw
materials with chemical elements not up to the standard mixed into them, resulting in the phenomenon that the chemical elements in the aluminum veneer products seriously exceed the standard.
4. The masurement is not timely
In the aluminum
veneer coating process, the solution virus needs to be configured. If the configuration is not carried out according to relevant regulations and the concentration of solution is not determined in time, the oxide film will be thinner and can not reach
the standard thickness.